10.0

really awful
Crashes / Fires:
0 / 0
Injuries / Deaths:
1 / 0
Average Mileage:
77,500 miles

About These NHTSA Complaints:

This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.

So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.

2013 BMW 328 drivetrain problems

drivetrain problem

Find something helpful? Spread the word.
Get notified about new defects, investigations, recalls & lawsuits for the 2013 BMW 328:

Unsubscribe any time. We don't sell/share your email.

2013 BMW 328 Owner Comments

problem #2

Oct 192019

328 4-cyl

  • 88,000 miles

A D V E R T I S E M E N T S

Drivetrain malfunction light came on stating to drive moderately. Maximum drivetrain output not available. Consult service center. The codes was cda904 no message (status trailer 0X2E4) receiver engine ECU transmitter trailer. 130F20 exhaust camshaft offset angel to crankshaft outside tolerance; 120408 boost pressure control, cut off pressure rise block after paying $180 for diagnostic I was told today that I need to replace the timing chain/ guild. Replace oil pump chain module and replace the valve cover. The timing chain guide is broken. This is crazy my car has 88000 miles and is not paid for. The cost to get this repaired is approxmiately $6,000. There is a current class action lawsuit. BMW knows that this is a problem but refuses to do a recall. The plaintiffs take issue with two specific defects in the engine's chains. The first defect affects the primary chain, also known as the timing chain, which coordinates the action of the crankshaft, camshafts, and cylinder valves. According to the plaintiffs, the plastic guide assembly for the primary chain is made of a defective polycarbonate material that becomes brittle and breaks apart, creating debris that lodges in the crankshaft drive sprockets. The debris can cause the primary chain to skip, letting the camshafts and crankshaft fall out of sync and possibly damaging or destroying the engine. The second defect affects the secondary chain, which connects the oil pump and balance shaft assembly to the crankshaft. The materials in this assembly can't stand up to high-resistance wear, the plaintiffs say. This defect causes the chain to elongate prematurely, slip, and damage the chain sprocket.

- Philadelphia, PA, USA

problem #1

Jun 142018

328

  • 67,000 miles
The contact owns a 2013 BMW 328I. While driving 50 mph, the oil pump and drivetrain warning indicators illuminated. While depressing the accelerator pedal, the vehicle violently jerked and stalled. As a result, the contact sustained injuries to the breast, but did not require medical attention. The contact attempted to restart the vehicle, but was unsuccessful. The contact was in heavy traffic and was not able to coast to the side of the road. The vehicle was towed to rallye BMW (1 brush hollow rd, westbury, NY 11590, (516) 393-0000) where it was diagnosed that the oil pump and drivetrain needed to be replaced. The vehicle was not repaired due to the repair fees. The manufacturer was notified of the failure and did not assist. The approximate failure mileage was 67,000. The VIN was not available.

- Freeport, NY, USA

Search CarComplaints.com for these popular complaint phrases...

Not what you are looking for?