1.7

hardly worth mentioning
Crashes / Fires:
0 / 0
Injuries / Deaths:
0 / 0
Average Mileage:
100,333 miles

About These NHTSA Complaints:

This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.

So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.

2012 Audi Q7 drivetrain problems

drivetrain problem

Find something helpful? Spread the word.
Get notified about new defects, investigations, recalls & lawsuits for the 2012 Audi Q7:

Unsubscribe any time. We don't sell/share your email.

2012 Audi Q7 Owner Comments

problem #3

Jun 062020

Q7 6-cyl Diesel

  • 121,000 miles

A D V E R T I S E M E N T S

Crank pulley hard rubber core or so called harmonic balancer broke and serpentine belt fell off causing to loose power steering and not be able to steer. I was pulling out of a highway ramp and thankfully other cars were able to avoid me due to the low traffic at the time of the incident.

- Peoria, IL, USA

problem #2

Dec 022019

Q7

  • 80,000 miles
Crankshaft pulley ripped itself apart at idle after vehicle was started.

- Frederick, MD, USA

problem #1

Jul 292017

Q7

  • 100,000 miles
The transmission oil cooler pressure line got a hole in it and leaked all of the transmission fluid out. The mechanic stated that there was plastic that was visibly seen rubbing against this metal line which over time wore the line down so much that it created a hole allowing the fluid to leak out. I was on the highway when I noticed the car not wanting to shift, down-sh*t etc when I finally pulled over noticed it was leaking from the front of the car. Once the fluid was just about out the Audi warning system finally notified me that there was an issue with the transmission. A tad late if you ask me. The car was starting to rev up the RPM's then suddenly it would slam into gear. I have had the line replaced and now it seems like I'm due for a new transmission due to all of this. The mechanic even stated he has never seen plastic wear through metal nor have I.. I question what pathetically weak metal was used on a high pressure line that would allow plastic to eventually rub through it all. I've asked the shop to keep the line and to snap some pictures for me, so I'm hoping I will have a chance to upload these once I receive them.

- Aurora, CO, USA

Search CarComplaints.com for these popular complaint phrases...

Not what you are looking for?