- October 28: Audi Alternator Failure Lawsuit Settlement Approved news | 23 days ago
- October 13: Honda Infotainment Lawsuit Says Speakers Make Popping Noise news | 38 days ago
- October 12: Recall: Audi e-tron GT and RS e-tron GT Battery Problems recalls | 39 days ago
- September 14: Honda Argues Unintended Braking Lawsuit Should Be Tossed news | 67 days ago
- August 24: Audi e-tron Quattro SUVs Recalled to Replace Brake Boosters recalls | 88 days ago
Audi TSB #A461523 2034181-
2014 Audi Q5
TSB Document:
Affected Component: BRAKES (PWS)
- Summary
- Supersedes Technical Service Bulletin Group 46 number 15-02 dated February 9, 2015. The customer may report hearing brake noise from front or rear brakes. The customer may describe these noises as a squeal, squeak, grinding, groaning, thumping, or creaking. DO NOT use this TSB if there is another brake noise TSB applicable to the VIN. For additional information, refer to the Audi Brake systems brochure. Brake noise can be attributed to many causes. Brake discs or brake pads are close to or below their wear limit. New brake pads and/or discs have not been properly imbedded after installation. Aftermarket pads or discs are installed. There is debris (such as small stones, grit, road salt, or sand) between brake disc and brake pad. Discs are covered with rust. Rust can form when the vehicle has not been driven for a long period of time. Discs are grooved. There is chemical contamination on the braking surface of the brake disc due to wheel or tire cleaner being sprayed directly onto the brake disc. There are ?pad marks? on the brake disc as a result of brake pad material transferring to the discs. Pad marks can occur when a vehicle has been parked for long periods of time in a wet or snowy environment.
Click a tab for more information.