- October 28: Audi Alternator Failure Lawsuit Settlement Approved news | 23 days ago
- October 13: Honda Infotainment Lawsuit Says Speakers Make Popping Noise news | 38 days ago
- October 12: Recall: Audi e-tron GT and RS e-tron GT Battery Problems recalls | 39 days ago
- September 14: Honda Argues Unintended Braking Lawsuit Should Be Tossed news | 67 days ago
- August 24: Audi e-tron Quattro SUVs Recalled to Replace Brake Boosters recalls | 88 days ago
Audi TSB #A961377 2035047-
2014 Audi A5
TSB Document:
Affected Component: LANE DEPARTURE
- Summary
- Supersedes Technical Service Bulletin Group 96 number 13-72 dated August 26, 2013. Audi Lane Change Assistant deactivates or is sporadically inoperative when the vehicle is driven in slowmoving stop-and-go traffic, especially on roads with multiple lanes. The message "Audi side assist unavailable: Sensors blocked" appears in the driver information system. The system is able to be activated approximately ten minutes after the traffic condition is removed, or after an ignition cycle. Audi Lane Change Assistant can be activated without issue. No obstructions can be found. DTCs are stored in the Lane Change Assistance control module. The control module mounting brackets are securely fastened to the lower rear bumper, and no damage is found to the rear bumper area, on the inside or outside. (If any damage is found, it is not covered under warranty.) The control module mounting brackets are not broken or loose. If a loose bracket is found, repair as necessary using the Elsa Repair Manual. Submit a separate warranty claim, as this TSB does not cover this repair.
Click a tab for more information.